![]() ![]() I don't remember the exact buffer size but I was able to get it quite low. To be fair, very few interfaces in this price range (or this diminuitive size & form factor) offer any digital I/O at all in the first place. If you have no plans on using the digital inputs you should be fine. The digital outputs of the Audio 6 work great. The Babyface was the only thing I could find that met all my requirements for portability, direct monitoring, signal routing flexibility, amount/type of I/O, USB, and works with all my existing gear. And they have direct monitoring of the digital inputs via software mixer. Record audio in immaculate quality up to 192 kHz / 24-bit. Both of those receive the TOSlink signal coming from my TC Electronic. I've tested the Babyface digital input as well as my previous interface (Motu 828mkII). And I needed something that worked with my existing gear now, rather than waiting for a driver fix that may or may not come. Are older NI audio interface drivers compatible with the Apple M1 chip SB31 Member Posts: 1 Newcomer. If Im in Cubase I simply disconnect Komplete Audio 6 and then re-establish the connection in audio connections. As a starter pack interface therefore, Komplete Audio 6 is a bit of a killer. Issue is that audio starts to break up, really, really bad crackles. This is a 1,000-sound preset suite of plugs and sounds taken from their Komplete 7 premium synth package. I had to buy an RME Babyface because I absolutely needed the 2 things above. Computer specs should run Cubase with no issues. The conclusion was that I tried everything & maybe the driver can be updated to improve external sync. I spent several hours on it & contacted support. I was able to get signal directly from a Lavry converter SPIDF output, but the Audio 6 will not lock to a TC Electronic rack FX via SPIDF. I shouldn't have assumed just because it says direct monitoring that it's for all the inputs.Ģ.) The clock of the digital input is unreliable syncing external to the incoming device. This is just the way it is, but was not obvious to me before purchasing. There is no software "control panel mixer". You are only able to directly monitor the analog inputs via the knobs on the hardware. If your device is not lighting up when connecting it, verify that the latest Controller Editor version has been installed. I have one, I had intended to use it as my only audio interface but I ran into a few issues concerning the digital inputs.ġ.) Direct (latency free) monitoring is not supported with the digital inputs. Note that any issues observed with these devices should be handled separately: If your device is not playing any audio, verify that the correct driver / Device Updater has been installed. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |